Malish ZRPLR150 riser for attaching clutch plates to brushes or pad holders 1.5 inch high with a 5 inch center hole gw

MALISH - The World's Premier Brush Maker!!

Riser For Attaching Clutch Plates To Brushes or Pad Holders For Floor Buffers, 1.5 Inch High With A 5 Inch Center Hole, Malish, ZRPLR150. A Riser is used to lower the brush or pad holder for improved floor contact or to get the brush below the floor buffer deck housing. Risers are mounted between the clutch plate and the brush block. Longer screws will easily hold both the clutch plate and the riser on to the brush block.

Riser

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerService@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.