MALISH - The World's Premier Brush Maker!!
Floor Buffer Pad Holder Malish Mighty Lok Plastic Hook Face With Clutch Plate and Riser 17 Inch Block Fits Most 18 Inch Floor Buffers Using Universal Clutch Plate NP9200, Malish, 786717-NP9200.
Pad Holders attach to floor buffers and use molded in hooks for holding floor buffer pads onto the bottom of floor buffers. Showerfeed holes allow use with solution dispensing machines.
- Designed to fit 18 Inch machines, this 17 Inch Plastic Block Pad Holder Uses 18 Inch Floor Buffer Pads.
- The Universal Clutch Plate NP9200 with built in riser (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Sanitaire, Thoromatic, Tornado, United, Viper.
FREE SHIPPING PROMOTION Delivers Your New Pad Holder To Your Door! (Continental US Address Only)
Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.
NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerService@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.