MALISH - The World's Premier Brush Maker!!
Floor Scrubber Buffer Pad Holder Malish Pad Lok Half Inch Trim With Clutch Plate and Riser 18 Inch Block Fits 19 Inch Floor Scrubbers Using Clutch Plate NP46, Malish, 782718-NP46.
Pad Holders attach to floor buffers and use stiff half inch brush bristles for holding floor buffer pads onto the bottom of floor buffers. Showerfeed holes allow use with solution dispensing machines.
- Designed to fit 19 Inch machines, this 18 Inch Plastic Block Pad Holder Uses 19 Inch Floor Buffer Pads.
- The NP-46 clutch plate with built in riser (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting mostly Hild Floor Machines.
FREE SHIPPING PROMOTION Delivers Your New Pad Holder To Your Door! (Continental US Address Only)
Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.
NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerService@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.