MALISH - The World's Premier Brush Maker!!
Kent Auto Scrubber Pad Holder With Pad Centering Device Malish Pad Lok One Half Inch Trim With Clutch Plate And Riser 12 Inch Block Fits 26 Inch Kent Razor Plus 26D, Requires Two Pad Holders, Using Clutch Plate 4148PMB, Malish, 782712-2460-4148PMB.
Pad Holders attach to floor buffers and use stiff one half inch brush bristles for holding floor buffer pads onto the bottom of floor buffers. Pad Centering Device locks pad to center for improved performance. Showerfeed holes allow use with solution dispensing machines.
- Designed to fit 26 Inch machines, this 12 Inch Plastic Block Pad Holder Uses 13 Inch Floor Buffer Pads.
- The Clutch Plate 4148PMB (attaches block to machine) is a durable plastic standard 5 inch center hole size.
FREE SHIPPING PROMOTION Delivers Your New Pad Holder To Your Door! (Continental US Address Only)
Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.
NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerService@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.