The Hawk CLAW Diamond Driver provides peak performance to the natural stone and concrete tradesman. The CLAW DPD is available in four sizes 13, 15, 17, and 20 inches. Allows you to drive multiple tools including: 3 inch round resin and metal, pin sets, trapezoids and PCD's all from one driver.
The weighted DPD plate is built from plate steel and e-coated for corrosion resistance and easier clean up. Diamond tools are secured in place industrial magnets. 3 inch resin tools recesses secure diamond tooling on rough surfaces. Available adaptor plates make the Claw a quick change driver for rapid movement from one grade tool to the next.
The 1.5 inch riser is made from neoprene rubber isolators for reduced vibration and flex over high points and lippage. custom milled NP9200 Clutch plate makes it usable on most rotary equipment.
- Designed to fit 17 Inch machines, this 17 Inch Plastic Block Pad Holder.
- The Universal Clutch Plate NP9200 with built in riser (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Sanitaire, Thoromatic, Tornado, United, Viper.
- Steel Plate Construction. E-Coated for corrosion resistance
- built with our meticulous machined anti seize aluminum clutch plate
- Round and Trapezoid recesses secure diamond tooling on rough surfaces.
- Metal tools are held in place with the Hawk unique Mag-Loc System
- Resin tool are held in place with metal adapter plates or Velcro mounting.
- For Product Brochure (CLICK HERE).
Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.
NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerService@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.
